Our standard bladder accumulator is designed for energy storage, pulsation dampening, shock absorption in the hydraulic system, consisting of a molded rubber bladder inside a forged steel shell with a nitrogen gas valve on one end and a fluid port at the other. All of our bladder accumulators are ASME code stamped and interchangeable with most of major brands on the market. The bladders, anti-extrusion rings, O-rings and seals are all made in USA. They are widely used in hydraulic power units, blowout preventer (BOP) systems, surge suppressions, pump pulsation controls, etc. with the following major features:
• Rapid response to pressure changes and work cycle
• Complete separation of gas and fluid
• Highly resistant to fluid contamination
• Low maintenance, trouble-free operation
• Readily available, low cost replacement parts
• Eliminates costly down time on expensive systems due to simple repair
Specifications:
COATING
STANDARD: Black Primer exterior, Oil interior
PRIMER PAINT: Double coat Primer Exterior
EPOXY COATING: Interior & Exterior, shell only
WATER & CHEMICAL SERVICE: Nickel plate coating on shells and components; stainless shell, fluid port and anti-extrusion ring
SERVICE TEMPERATURE
STANDARD: -40° F to 200° F (-40° C to 94° C)
RATED PRESSURE
3,000/6,600 psi, Tested in accordance with ASME Boiler & Pressure Vessel Code Section VIII, Division 1, ASME Certified, U Stamped
SPECIAL CONFIGURATIONS
Noted by “X” at end of Model Number, defined by Part Number and Assembly Drawing
Our bladder accumulators are made in US and interchangeable with most of brands on the market, such as Parker, Greer, Oil Air, Accumulators, HYDAC, Tobul, etc.
Please check our new accumulator site for more details
Please check our accumulator Sizing Tool page to determine your new application. If you need help for sizing or selecting the accumulator for your project, please download and fill out the Accumulator Application Form and send to us.
[/vc_column_text]